Total Hydrocarbons Analyzer VIG 20-E
Introduction
The VIG Industries Model 20-E is a microprocessor based, oven heated total hydrocarbon gas analyzer design for high accuracy, sensitivity and stability. The Model 20-E uses a flame ionization detector (FID) for continuous measurement. All components that come in contact with the sample through analysis are maintained in a temperature controlled avec to prevent condensation, and to provide repeatable, reliable performance in the analysis of a wide variety of hydrocarbon concentrations in gaseous mixtures or in ambient air.
Applications
- Prcoess gas control
- Measuring industrial waste emissions
- Verifying extraction systems, thermal catalyste, ect
- Testing engine gases (automative, aeronaitics, ect.)
- Combustion gas control
- Quantifying fugitive enissions
Features
- Easy to use software
- Ready to measure within 45 minutes
- Precision 1% of full scale
- Fast response
- Two stages sample filters with exchangeable elements
- Automatic ignition
- Built-in spare igniter
- Automatic fuel shut off system
- Automatic ranging
- Choice of hydrogen or hydrogen/helium fuel
- Easy and low cost maintenance
- NF EN 15267-3 and XPX 43 554 compliance
Specifications
- Measuring method : 190 °C heated Flame ionization detector
- Ranges : 0-10-100-1000-10000 ppm (limit 0.01 ppm) / 0-100-1000-10000-100000 ppm (limit 0.1 ppm) Other ranges available upon request
- Flow : 2 l/min
- Sensibility : Within 0.2% of full scale
- Drift : Within +/-1% full scale per 24H
- Linearity : Within 2% full scale
- Repeatability : Within 1% full scale
- Stability : Within 1% full scale
- Response time : Within 5 seconds
- Analog output : 0-10 VDC or 4-20 mA
- Dimensions : 19’’ rack, 425(L) x 610(P) x 230(H) mm
- Weight : 18 kg to 25 kg depending on options
- Ambient temperature : 10°C – 50°C
- Power : 230VAC (50Hz) or 115VAC (60 Hz) and 700 W
Options
- Automatic calibration
- Two individual measuring channel
- Dilution system for very high concentration
- External air, H2 and nitrogen generator
- RS-232 interface
- ISO 17025 calibration report following NF EN 15267-3 and XPX 43 554
Gas requirement
- Fuel : H2 (100%) or H2/He (40/60%)
- Air : Air zero instrumentation @ 18 PSI
- Zero : Air or Nitrogen @ 9 PSI
- Span : Methane or propane @ 9 PSI